MATERIAL SAFETY DATA SHEET Section I. Identity Product Name: Microcrystalline Cellulose USP, FCC Manufacturer: AMALFI INGREDIENTS Manufacturer’s Address: 94 E. Jefryn Blvd,Unit H, Deer Park, NY 11729 Manufacturer’s Phone #: 631-392-1526 Chemtrec Phone #: 800-424-9300 Date Prepared: JUNE 2006 Section II. Hazardous Ingredients/Identity Information Hazardous Components (Specific Chemical Identity: Common Name (s)) OSHA PEL ACGIH TLV Other limits recommended % Components: Microcrystalline Cellulose CAS # 9004-34-6 15 mg/m3 10 mg/m3 97+% Section III. Physical/Chemical Characteristics Boiling Point: N/A Vapor Pressure (mm Hg.): N/A Vapor Density (AIR=1): N/A Solubility in Water: Insoluble Specific Gravity (H2O=1): 0.2-0.5 Melting Point: N/A Evaporation Rate (Butyl Acetate=1): N/A Appearance & Odor: white free flowing powder, odorless Section IV. Fire & Explosion Hazard Data Flash Point: 420o C Flammable Limits: N/A Extinguishing Media: Water; CO2; dry chemical LEL: N/A UEL: N/A Special Fire Fighting Procedures: Full protective clothing and SCBA Unusual Fire & Explosion Hazards: N/A Section V. Health Hazard Data OSHA Regulate: Carcinogen – NTP Program: No Carcinogen – IARC Program: No Health Hazards (Acute Chronic): N/A Signs & Symptoms of Exposure: N/A Medical Conditions Aggravated by Exposure: Routes of Entry: Inhalation - yes, skin - no, ingestion - yes Emergency First Aid: If in eyes - flush with water for 15 min. In case of inhalation - remove victim to fresh air. Section VI. Reactivity Data Stability: Stable Conditions to Avoid: N/A Incompatibility (Materials to Avoid): N/A Hazardous Decomposition or Byproducts: N/A Hazardous Polymerization: Will not occur Section VII. Precautions for Safe Handling and Use: Steps to Be Taken in Case Materials are Released or Spilled: Vacuum or sweep up. Place in container for disposal. Waste Disposal Method: Normal, in accordance with local regulations. Precautions to Be Taken in Handling and Storing: Store in a dry place. Maintain 18" clearance between top of storage and ceiling sprinklers. Section VIII. Control Measures Eye Protection: Recommended Local Exhaust: Recommended Respiratory Protection: NIOSH/MSHA, EU CEN or comparable equivalents Other Protective Clothing or Equipment: N/A Protective Gloves: N/A Ventilation: N/A DISCLAIMER: The information in this MSDS was obtained from current and reliable sources. However , the data is provided without any warranty , expressed or implied, regarding its correctness or accuracy. Since the conditions of handling, storage and disposal of this product are beyond our control, it is the responsibility of the user both to determine safe conditions for use of this product and to assume full responsibility for loss, injury and expense arising out of product’s improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage use or disposal of this product which may not be covered in this MSDS. The user is responsible for full compliance. |