MATERIAL SAFETY DATA SHEET Section I. Identity Product Name: AMALFI 7A Manufacturer: AMALFI INGREDIENTS Manufacturer’s Address: 94 E. Jefryn Blvd,Unit H, Deer Park, NY 11729 Manufacturer’s Phone #: 631-392-1526 Chemtrec Phone #: 800-424-9300 Date Prepared: JUNE 2006 Section II. Hazardous Ingredients/Identity Information Hazardous Components (Specific Chemical Identity: Common Name (s)) Other limits recommended % OSHA PEL ACGIH Threshold Limit Value (units) Components: Corn Oil CAS # 8001-30-7 Mono Glyceride Citrate CAS # 91744-23-9 Propyl Gallate CAS # 121-79-9 Section III. Physical/Chemical Characteristics Boiling Point: N/D Vapor Pressure (mm Hg.): N/D Vapor Density (AIR=1): N/D Solubility in Water: Nil Specific Gravity (H2O=1): 0.96 Melting Point: N/A Evaporation Rate (Butil Acetate=1): N/A Appearance & Odor: Amber to greenish color liquid with characteristic odor Section IV. Fire & Explosion Hazard Data Flash Point: COC 446o F Flammable Limits: N/A Extinguishing Media: Water spray, foam, dry chemical, CO2 LEL: N/A UEL: N/A Special Fire Fighting Procedures: Self contained breathing apparatus and protective clothing should be worn fighting fires. Unusual Fire & Explosion Hazards: None known to Amerol Section V. Health Hazard Data OSHA Regulate: Carcinogen – NTP Program: Carcinogen – IARC Program: Health Hazards (Acute Chronic): May cause slight irritation Signs & Symptoms of Exposure: Medical Conditions Aggravated by Exposure: Routes of Entry: Inhalation - yes, skin - none known, ingestion - toxicity not established Emergency First Aid: Flush eyes with water for at least 15 minutes. Flush skin with water. Remove from exposure, treat symptomatically and call physician if symptoms persist. Section VI. Reactivity Data Stability: Stable Conditions to Avoid: N/A Incompatibility (Materials to Avoid): Strong oxidizing material can cause a reaction Hazardous Decomposition or Byproducts: Consider as organic material - produces CO2 and/or CO when burned Hazardous Polymerization: Will not occur Section VII. Precautions for Safe Handling and Use: Steps to Be Taken in Case Materials are Released or Spilled: Sweep or vacuum spilled material into an appropriate container. Waste Disposal Method: Incinerator or landfill observe all Federal, Local Laws concerning health and environment. Precautions to Be Taken in Handling and Storing: Protecting gloves should be worn, safety glasses for eye protection. Use full face respirator for vapor protection. Other Precautions: Protection in handling. Good industrial hygiene practice should be followed. Avoid eye contact. Minimize skin contact and vapor inhalation. Section VIII. Control Measures Eye Protection: Safety glasses should always be worn Local Exhaust: Recommended Respiratory Protection: Use full face respirator Mechanical (General): 10 air changes/hour Protective Gloves: Recommended Ventilation: Recommended Work/Hygienic Practices: Eye bath, washing facilities. DISCLAIMER: The information in this MSDS was obtained from current and reliable sources. However , the data is provided without any warranty , expressed or implied, regarding its correctness or accuracy. Since the conditions of handling, storage and disposal of this product are beyond our control, it is the responsibility of the user both to determine safe conditions for use of this product and to assume full responsibility for loss, injury and expense arising out of product’s improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage use or disposal of this product which may not be covered in this MSDS. The user is responsible for full compliance. |