MATERIAL SAFETY DATA SHEET Section I. Identity Product Name: AMALFI 6 Manufacturer: AMALFI INGREDIENTS Manufacturer’s Address: 94 E. Jefryn Blvd,Unit H, Deer Park, NY 11729 Manufacturer’s Phone #: 631-392-1526 Chemtrec Phone #: 800-424-9300 Date Prepared: JUNE 2006 Section II. Hazardous Ingredients/Identity Information Hazardous Components (Specific Chemical Identity: Common Name (s)) Other limits recommended % OSHA PEL ACGIH Threshold Limit Value (units) Components: Vegetable Oil BHA CAS #25013-16-5 BHT CAS #128-37-0 Propyl Gallate CAS #121-79-9 Citric Acid CAS #77-92-9 Glycerol Mono Oleate CAS #25496-72-4 Propylene Glycol CAS #57-55-6 Section III. Physical/Chemical Characteristics Boiling Point: 482o C Vapor Pressure (mm Hg.): N/A Vapor Density (AIR=1): N/A Solubility in Water: Certain components are appreciably soluble, others are insoluble Specific Gravity (H2O=1): 1.008 Melting Point: < 0o C Evaporation Rate (Butil Acetate=1): N/A Appearance & Odor: Amber colored liquid with slight odor Section IV. Fire & Explosion Hazard Data Flash Point: 113o C. (COC) Flammable Limits: N/A Extinguishing Media: Foam; CO2; dry chemical LEL: N/A UEL: N/A Special Fire Fighting Procedures: Wear self contained breathing apparatus and protective clothing Unusual Fire & Explosion Hazards: None Section V. Health Hazard Data OSHA Regulate: Carcinogen – NTP Program IARC Program: BHA is a suspect material Health Hazards (Acute Chronic): May cause eye or respiratory irritation at elevated temperatures. Ingestion may cause irritation of the GI tract. Signs & Symptoms of Exposure: Possible allergic reaction Medical Conditions Aggravated by Exposure: Asthma, conjunctivitis, bronchitis, allergies. Routes of Entry: Inhalation - no, skin - yes, ingestion - yes Emergency First Aid: Remove person to fresh air. Seek medical attention if serious. If in eyes, flush with water for 10 minutes. Section VI. Reactivity Data Stability: Stable Conditions to Avoid: N/A Incompatibility (Materials to Avoid): Powerful oxidizing or reducing agents Hazardous Decomposition or Byproducts: Hazardous Polymerization: Will not occur Section VII. Precautions for Safe Handling and Use: Steps to Be Taken in Case Materials are Released or Spilled: Absorb spill with Vermiculite, sand or other inert material, then place in a suitable container for chemical waste removal. Wash area down with soap and water to remove any slippery conditions. Waste Disposal Method: Normal, in accordance with local and state regulations. Precautions to Be Taken in Handling and Storing: Avoid high heat, intense sunlight. Other Precautions: Good general ventilation should be observed. Eye bath and washing facilities available. Section VIII. Control Measures Eye Protection: Recommended Local Exhaust: Recommended Respiratory Protection: In accordance with OSHA Standard 29 CFR 1910.134 Other Protective Clothing or Equipment: Wear full face protector if needed Protective Gloves: Recommended Ventilation: N/A Work/Hygienic Practices: Wash with soap and water after contact and before eating. DISCLAIMER: The information in this MSDS was obtained from current and reliable sources. However , the data is provided without any warranty , expressed or implied, regarding its correctness or accuracy. Since the conditions of handling, storage and disposal of this product are beyond our control, it is the responsibility of the user both to determine safe conditions for use of this product and to assume full responsibility for loss, injury and expense arising out of product’s improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage use or disposal of this product which may not be covered in this MSDS. The user is responsible for full compliance. |