Amalfi Ingredients

MATERIAL SAFETY DATA SHEET

Section I. Identity

Product Name: Amalfi EXTEND-OX 10E
Manufacturer: Amalfi Ingredients
Manufacturer’s Address: 94 E.Jefryn Blvd, Unit H, Deer Park, NY 11729
Manufacturer’s Phone #: 631-392-1526
Chemtrec Phone #: 800-424-9300
Date Prepared: June 2006

Section II. Hazardous Ingredients/Identity Information

Hazardous Components (Specific Chemical Identity: Common Name (s)) Other limits recommended %
OSHA PEL ACGIH Threshold Limit Value (units)
Components:
Canola Oil
Butylated Hydroxytoluene   

Butylated Hydroxyanisole   

Stearyl Citrate                   

Section III. Physical/Chemical Characteristics

Boiling Point: N/A
Vapor Pressure (mm Hg.): N/A
Vapor Density (AIR=1): N/A
Solubility in Water: N/A
Specific Gravity: 0.92-0.94
Viscosity: 50-100 cps  
Evaporation Rate (Butil Acetate=1): N/A
Appearance & Odor: Light Amber & Bland Odor

Section IV. Fire & Explosion Hazard Data

Flash Point:
Flammable Limits: N/A
Extinguishing Media: None
LEL: N/A
UEL: N/A
Special Fire Fighting Procedures: None
Unusual Fire & Explosion Hazards: None

Section V. Health Hazard Data

OSHA Regulate:
Carcinogen – NTP Program: Suspect (Group 2B)
Carcinogen – IARC Program: 
Health Hazards (Acute Chronic): Mildly toxic if ingested in very large quantities
Signs & Symptoms of Exposure: 
Medical Conditions Aggravated by Exposure: Allergic sensitivities (MCS)
Routes of Entry: Ingestion - possible
Emergency First Aid: Wash affected area with soap and water. Consult with physician. Remove person to fresh air.

Section VI. Reactivity Data

Stability: Stable
Conditions to Avoid: N/A
Incompatibility (Materials to Avoid):
Hazardous Decomposition or Byproducts:
Hazardous Polymerization: Will not occur

Section VII. Precautions for Safe Handling and Use:

Steps to Be Taken in Case Materials are Released or Spilled: Sweep or vacuum spilled material into an appropriate container. Use absorbent material.
Waste Disposal Method: Normal. In accordance with all applicable regulations (State and Local)
Precautions to Be Taken in Handling and Storing: Away from high heat and all ignition sources.
Other Precautions: Store in cool, well-ventilated area <100°F

Section VIII. Control Measures

Eye Protection: Recommended
Local Exhaust: 
Respiratory Protection: Mask or respirator if mist or vapor occur
Other Protective Clothing or Equipment: Work uniform.
Protective Gloves: Recommended
Ventilation: Recommended
Work/Hygienic Practices:

DISCLAIMER:

The information in this MSDS was obtained from current and reliable sources. However , the data is provided without any warranty , expressed or implied, regarding its correctness or accuracy. Since the conditions of handling, storage and disposal of this product are beyond our control, it is the responsibility of the user both to determine safe conditions for use of this product and to assume full responsibility for loss, injury and expense arising out of product’s improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage use or disposal of this product which may not be covered in this MSDS. The user is responsible for full compliance.